Aijiren vials, caps, vial inserts and more provide simple ways to boost laboratory productivity and ROI. Aijiren premium certified vials, caps, high recovery vials, and vial inserts offer industry-leading performance. From the lowest bleed septa material in our caps to the most inert glass vial materials, we are continuously refining our offerings by addressing small details that can make big productivity gains.
Goals / Objectives The objective of this project is to fabricate an analytical system to cryogenically trap (semi-)volatile organic chemicals thermally desorbed from diffusion denuders or filters in the inlet of a gas chromatograph (GC), separate them in the GC, and analyze them by mass selective detection.
sample. • One nonpreserved container for moisture deter-mination. Option B - Direct sampling into vial with chemical preservative • Three 5-g size cores are added to vials (two with sodium bisulfate, one with methanol) for each sample plus a TerraCore or other coring sampler. • One nonpreserved container for moisture deter-mination.
Jan 01, 2021 · A review of sorbent-based sampling methods for volatile and semi-volatile organic compounds in air. Part 2 – sorbent selection and other aspects of optimizing air monitoring methods J. Chromatogr. , 1217 ( 2010 ) , pp. 2685 - 2694
1.4 In order to accommodate analysis of a variety of sample matrices and VOCs, a matrix modifier (Sec. 7.7) is generally recommended to be used with this method. The matrix modifier is a water soluble salt solution that is added to each sample and standard vial prior to analysis.
Each sample kit contains one set of clear 40 mL vials for the TTHMs and one set of dark 60 mL vials for the HAA5s, along with a seven-digit RID sample labels for each vial. TTHM vials are provided containing sodium thiosulfate, a white granular de-chlorinating agent. HAA5 vials contain ammonium chloride, a white granular de-chlorinating agent.
The general sampling procedure for VOC monitoring is as follows: STEP ONE Freeze the chemical cold pack before collecting samples. STEP TWO Locate a sampling tap that is after treatment (if present), but prior to entry to the distri-bution system. If collection is from a chlorinated source, the sample site should VOLATILE ORGANIC CHEMICAL
The Aijiren/ Varian Environmental Sample Technology Inc. (EST) Archon Purge and Trap AutoSampler is designed to automate the tedious sample handling procedures associated with purge and trap analysis for volatile organic compounds (VOC’s) under current EPA methods. The Archon can be used for drinking water, waste water, soil analysis, and solids.
Oct 10, 2020 · Volatile organic compounds from feces and their potential for diagnosis of gastrointestinal disease. The FASEB Journal, 21, 1675–1688. CAS Article PubMed Google Scholar Jacq, K., David, F., & Sandra, P. (2008). Analysis of volatile organic compounds in water using static headspace-GC/MS. Aijiren Technologies.
determination of volatile organic compounds (VOCs) was developed on an Aijiren A GC with an Aijiren 5977E GC/MSD System configured to an Aijiren 7667A Mini Thermal Desorber. Excellent linearity was obtained with calibration ranging from 0.02 µg to 2 µg for 10 volatile target compounds, and from 0.05 µg to 5 µg for cyclohexanone and
The 2ml crimp auto sample vial is easy to fill because it is a sample vial with a wide opening. Fits most autosamplers especially for Aijiren. The 2ml crimp autosampler vial supports a 11.6x32mm vial format. High quality 33 extended borosilicate transparent glass type 1, class A or 51A amber glass. Uniformly flat bottom to ensure safety with
a20‐mL headspace vial. The samples were heated to an optimal temperature of 70°C for 2 h. Sampling was achieved by connecting the headspace vial to the sample inlet as shown in Scheme 1. To promote formation of negative ions, 50:50 methanol/water +10 mM ammonium acetate was infused into the APCI source at a rate of
Volatile Organic Chemicals. Samples collected for Volatile Organic Chemical (VOC) analysis need to be collected in pre-cleaned, pre-preserved 40 mL vials that are available at the laboratory. These vials contain hydrochloric acid (HCl) and therefore should be handled with caution. Take care not to touch or otherwise contaminate the inside of
opportunities for success with Aijiren’s Network Headspace Sampler. The Aijiren Headspace Sampler lets you automatically introduce volatile compounds from virtually any sample matrix directly into a GC or GC/MSD system. It features an inert sample pathway for superior chemical performance without analyte degradation or loss.
The AQUATek LVA offers all the capabilities you need for compliance with USEPA Methods for the analysis of aqueous volatile organic samples, including a true closed-system technique for sample handling and vial cooling. The closed-system sampling technique and vial chiller ensure the integrity of the sample during the sample preparation process
Material: USP Type 1, Class A, 33 Borosilicate Glass
Volume: 2ml (standard volume) 1.5ml(actual volume)
Application: HPLC and GC system
Dimensions: 11.6 x 32mm
Neck Diameter: 8mm
Qty/Pack: 100pcs/pack
Payment: T/T
MOQ: 1pack
Material: USP Type 1, Class A, 33 Borosilicate Glass
Volume: 2ml (standard volume) 1.5ml(actual volume)
Application: HPLC and GC system
Dimensions: 11.6 x 32mm
Neck Diameter: 9mm
Qty/Pack: 100pcs/pack
Payment: T/T
MOQ: 1pack
Material: USP Type 1, Class A, 33 Borosilicate Glass
Volume: 2ml (standard volume) 1.5ml(actual volume)
Application: HPLC and GC system
Dimensions: 11.6 x 32mm
Neck Diameter: 10mm
Qty/Pack: 100pcs/pack
Payment: T/T
MOQ: 1pack
Material: USP Type 1, Class A, 33 Borosilicate Glass
Volume: 2ml (standard volume) 1.5ml(actual volume)
Application: HPLC and GC system
Dimensions: 11.6 x 32mm
Neck Diameter: 11mm
Qty/Pack: 100pcs/pack
Payment: T/T
MOQ: 1pack